MIL-DTL-62220C
3.3.8 Wire screens. Screens constructed of wire cloth conforming to ANSI/AWCI O1
shall be provided for ventilation (see Figure 2). The low carbon steel cloth shall consist of
0.047 diameter, 4 X 4 wire mesh which is hot galvanized after weaving. Hardware consisting of
30 pieces of P/N MS90725-58, hex head cap screw and 30 pieces of P/N MS27183-14, flat
washer, shall be provided to secure wire screens in place.
3.3.9 Boxes. Fiberboard boxes conforming to ASTM D5118/D5118M shall be provided
for packaging. The boxes shall be sealed in accordance with ASTM D1974. Wood boxes
conforming to class 2 of PPP-B-621 shall be used for packing.
3.4 Procedures and operations. Procedures and operations consist of general
requirements and special requirements. General requirements shall apply to all levels of
protection (see 3.4.1). Special requirements shall apply for the specified level of protection
(see 3.4.2).
3.4.1 General requirements. DA Form 2258 shall be completed to record the
preservation applied and deprocessing required for each vehicle. The completed forms shall be
heat sealed within a bag conforming to type I, class B, style 2 of MIL-B-117 and attached within
the driver's compartment.
3.4.1.1 Disassembly. Unless otherwise specified herein, each vehicle shall be prepared for
storage and shipment in a completely assembled condition after test runs, and completion and
approval of all necessary repairs. Specified equipment shall be installed and all adjustments made
so that vehicle may be placed into service with a minimum of delay.
3.4.1.1.1 Disassembly for normal transport. Unless otherwise specified (see 6.2), the
items listed in Table I, Table II and Table III shall be removed from the vehicle. Disassembly shall
be in accordance with the applicable technical manuals. Items removed from the vehicle for
normal transport shall be configured for packaging, stowage, and securement aboard the vehicle.
3.4.1.1.2 Disassembly for special transport modes. When specified (see 6.2), additional
disassembly shall be in accordance with the vehicle's transportability guidance for the specified
mode of transport and the applicable technical manuals.
3.4.1.1.3 Access covers, gaskets, and hardware. Unless otherwise specified (see 6.2), the
access covers, gaskets, and securing hardware shall be removed from the underside of the vehicle
(see Figure 2).
3.4.1.1.4 Personnel seats. Personnel seats shall be removed from their operating position.
3.4.1.1.5 Eye bolts. Eye bolts used to install and remove the hydraulic reservoir shall be
removed.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business