MIL-PRF-55585G(CR)
3.
REQUIREMENTS
3.1
Packaging
.
3.1.1 Military packaging
.
Military packaging shall be accomplished as
specified in MIL-STD-2073-1C.
3.1.2 Commercial packaging
.
Commercial packaging will be as specified
in ASTM D 3951.
3.2. Unitization
. Palletization shall be required when quantities per
destination exceed either a total of 250 pounds (excluding the pallet) or a
volume of 20 cubic feet. A quantity of items, packed for shipment, shall be
placed on pallets, standard size 40 by 48 inches as shown in MIL-HDBK-774. The
load shall be "bonded" to the pallet by any means that will ensure safe
delivery to destination.
3.3
Marking.
3.3.1 Military. In addition to any special marking required by the
contract or order, military marking shall be in accordance with the
requirements of MIL-STD-129. Further guidance is contained in MIL-HDBK-129.
3.3.1.1 Special marking requirements When required by the contract or
.
order, containers shall be marked as specified.
3.3.1.1.1 Sensitive electronic devices Unit, intermediate, and
.
exterior packs containing sensitive electronic devices susceptible to damage
from environmental field forces shall be marked in accordance with MIL-STD-129
and MIL-HDBK-129.
3.3.2
Commercial
.
Items shall be marked in accordance with ASTM D 3951.
3.4 Hazardous materials In addition to the requirements of this
.
specification, hazardous materials will be packaged, marked, and labeled
according to the hazardous materials regulations of the Department of
Transportation, Title 49 Code of Federal Regulations, Parts 100-199.
3.5 Workmanship
. The quality of workmanship shall be such as to permit
acceptance of the completed packing requirements in accordance with the
inspection provisions specified in section 4.
4.
VERIFICATION
4.1 Packing inspection Inspection of packing and the marking for
.
shipment and storage shall consist of the examinations specified in table I,
"Packing inspection provisions." Lot formation shall consist of all packs made
of the same materials during an identifiable period and submitted at one time
for acceptance. Sampling procedures shall be in accordance with
ASQC-Z1.4.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business