MIL-DTL-46709F(AT)
3.4.1.2.1.1 Battery supports and retainers. Battery supports and retainers shall be
cleaned with a solution of one-half pound of sodium bicarbonate conforming to A-A-374 per
gallon of water. After cleaning, cleaned surface shall be flushed with clean water and thoroughly
dried.
3.4.1.2.1.2 Backrests and seats. Backrest and seat cushions shall be cleaned with a
solution of detergent conforming to P-D-220 or type I of MIL-D-16791 and warm water. After
cleaning, cushions shall be wiped with a cloth saturated with clean water to remove cleaning
solution. Care shall be taken not to saturate the cushions with cleaning solution or water. After
rinsing, cushions shall be thoroughly dried.
3.4.1.2.1.3 Fire control items. Exposed optical glass components of fire control items
shall be cleaned and dried in accordance with good commercial practice for optics.
3.4.1.2.2 Exterior of vehicle. Exterior surfaces of the vehicle shall be cleaned with a
solution of water and detergent conforming to P-D-220 or type I of MIL-D-16791. After
cleaning, surfaces cleaned shall be rinsed with clean water and thoroughly dried. Exterior of
vehicle shall be cleaned without permitting entry of steam or water into driver's, crew, or engine
compartments. If pressure spraying equipment is used in the cleaning process, the control
regulation of the spraying equipment and the method of spray cleaning shall be sufficient to
prevent damage.
3.4.1.2.2.1 Cannon. The cannon shall be cleaned and dried by any suitable process or
processes which are not injurious to the cannon.
3.4.1.3 Preservation. Unless otherwise specified (see 6.2), each vehicle surface and
component which is susceptible to corrosion or deterioration by environmental conditions shall be
protected by application of selected preservatives in accordance with MIL-STD-2073-1.
Preservative materials, equipment, and processes shall be selected which are sufficient and safe
when used for the purpose intended. Selected preservatives shall be compatible with the item
composition and intended use. Preservation shall be completed immediately after cleaning and
drying. Any item damaged by preservation shall be replaced or repaired.
3..4.1.3.l COEI, BII, and disassembled items. COEI, BII, and disassembled items shall
be protected by methods of preservation in accordance with MIL-STD-2073-1 (see tables I, II,
and III).
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business